Professor Isono’s paper has been published in Polymers

August 14, 2026

A paper by Professor Takuya Isono of Hokkaido University’s Faculty of Engineering has been published in Polymers.

  • Chun-Yao Ke, Ryota Suzuki, Takuya Yamamoto, Takuya Isono, Guey-Sheng Liou,  and Toshifumi Satoh. Fluorine-Modulated Reactivity Enables One-Pot Kinetic Sequence Programming of Block Copolyesters. Polymers 2026, 18(16), 1977
    DOI: https://doi.org/10.3390/polym18161977

Abstract

Monomer sequence strongly influences copolymer properties, but direct block formation from a monomer mixture requires a large reactivity contrast. Here, fluorination was used to regulate anhydride reactivity in the cesium pivalate-catalyzed ring-opening alternating copolymerization (ROAC) of tetrafluorophthalic anhydride (FPA), phthalic anhydride (PA), and 3-perfluorohexyl-1,2-epoxypropane (PFE). Time-resolved nuclear magnetic resonance (NMR) spectroscopy showed that FPA reached >99% conversion before detectable PA incorporation. With 1,4-benzenedimethanol as a bidirectional initiator, this sequential consumption generated a central poly(FPA-alt-PFE) segment followed by poly(PA-alt-PFE) growth from both chain ends. Molar mass evolution, end-group analysis, and diffusion-ordered spectroscopy (DOSY) NMR collectively supported covalent block formation. Sequential incorporation was retained across three different FPA:PA feed ratios, and Beckingham–Sanoja–Lynd analysis yielded large and reciprocal effective reactivity-ratio descriptors (𝑟FPA≈8.3–8.6×102 and 𝑟PA≈1.2×10−3), consistent with the experimentally observed real-block regime. Matched model reactions further indicated faster FPA ring-opening and higher observed epoxide-opening reactivity in a fluorinated aromatic carboxylate model system. These results demonstrate that H-to-F substitution can provide the kinetic bias required to program block copolyester sequence within a single ROAC platform.

Keywords: block copolymer; ring-opening alternating copolymerization; fluorinated polyesters; monomer reactivity; sequence control

Graphical Abstract

Source: Ke, C.-Y., Suzuki, R., Yamamoto, T., Isono, T., Liou, G.-S., & Satoh, T. (2026). Fluorine-Modulated Reactivity Enables One-Pot Kinetic Sequence Programming of Block Copolyesters. Polymers, 18(16), 1977. DOI: https://doi.org/10.3390/polym18161977 License: This article is distributed under the terms of the Creative Commons Attribution 4.0 International (CC BY 4.0) License.